Laminate floors are the most popular choice of wood flooring as they are very easy to install, and are suitable for use over any type of subfloor i.e. concrete, wood and even including underfloor heating.

Floating Installation

 Floating Installation with click system laminate flooring is the most common fitting method. It is very much liked by both DIY and Professional installers as it is quick and easy to do. It can be installed over any type of subfloor and it does not require any professional skills as the floor just clicks together with no need for any glue.

Which underlay should you use?

Over a concrete subfloor you will need to use an underlay with a moisture barrier. While over a wooden subfloor you can use the standard underlay without a moisture barrier. For installations over underfloor heating we recommend using combi underlay with moisture barrier. (all underlay's can be bought on this website under the accessories sub menu)

Clicking the boards together

Each board has a click profile on all four sides.  Just simply insert the tongue into the groove at an angle and then push the board down into the other board it may require a tap to finally lock into place (you can buy the installation kit with the tapping block included on this website in the accessories range).

Expansion Gap

As with any wood floor you will need to leave an expansion gap, a 10mm expansion gap is required for laminate flooring around the perimeter of the room. To maintain this gap you will need to use spacers which are supplied in our installation kits.

After you have installed the floor you can cover this expansion gap either with scotia or new skirting board .The 10mm expansion gap also needs to be left in doorways where the floor follows through from one room to another.

PLEASE NOTE:

The above is just a helpful fitting guideline. Remember to always consult the installation instructions before fitting your new flooring.

Failure to adhere to manufacturers installation guidelines will invalidate your guarantee.